Programmer UPROG ICP / USB
For programming systems in the system (called. In-circuit). Programmer powered USB port only. To support a wide range of systems powered by voltages from 1.8V to 5V as well as requiring high voltage to 14V programming.
Control software for USB Uprog programmers, designed so that the service was the most intuitive.
Extensions to Uprog ICP
- Ulogic – analyzer Logic function digital waveform generator (pattern generator)
- Uprog ICP Programming -use of an additional plate ZIF socket
Programming in circuit – uprog ICP
Equipped with 14 pin connector – allows programming systems in the system. Supports interfaces: SPI, I2C, BDM, JTAG, 1 WIRE, 3 WIRE and interfaces in systems such as: 8051, AVR, ST72, PIC, MSP430
- ICP connector Features
- Adjustable level programming interface and programming voltage in the range: Vcc 1.8V – 5V, Vpp 5V – 14V
- the ability to supply the system with a programmable timer
- very fast data transfer
- flexible coupling system with programmable timer
- over current protection
- Programming systems in the system (in-circuit)
- USB 2.0 – tryb HighSpeed
- Powered from USB port – the ability to connect ext. power supply 6V
- Minimum programming times thanks to microprocessor FPGA
- Data management system
- Function pin check checking the correctness of contact between the programmer and the system
- Software for Windows 2000/XP/Vista/Win7/Win8 ( 32 and 64 bits)
- Dimensions : 110mm x 70mm x 25mm
- LED: Power, Busy, Error, Good
Data management system
With the software Uprog2 you can create a project with several different sets of data for each system. Furthermore, the pack will be able to join the state descriptions – relating to a specific version or attach a note, which describe the state assembly instructions